Asymmetry of the C2 pars interarticularis: a clinical anatomical study with relevance to screw placement Article

Full Text via DOI: 10.1007/s00276-022-02901-2 Web of Science: 000761896700001
International Collaboration

Cited authors

  • Huang B, Khan PA, Iwanaga J, Hur MS, Tubbs RS, Maulucci CM

Abstract

  • Purpose Potential asymmetries of the C2 posterior elements pose a problem for the spine surgeon seeking to make the best choice for spinal stabilization while reducing morbidity. Methods A digital caliper was used to measure the pars interarticularis height and length on left and right sides of 25 adult C2 vertebrae. The pars interarticularis was defined as the bone between the posterior most aspect of the superior articular process and the anterior most aspect of the inferior articular process of C2. Also, the C2 vertebrae from 49 patients were scanned by CT. Parasagittal images were reviewed and using the same definitions as were used for the skeletal specimens, the length and the height of the C2 pars interarticularis from both the left and right sides were measured using CT. The image slices were acquired at 3 mm intervals. The pars interarticularis height was determined on sagittal CT reconstruction, while the pars interarticularis length was calculated on the basis of the axial images. Results The lengths and the heights of the left and right pars interarticularis were compared using CTs of patients and skeletal specimens. No significant differences were found in the length and height measurements of the CT images on both sides. However, in the skeletal specimens, the left and right pars interarticularis did not differ significantly in length but differed significantly in height (p = 0.003). The mean height of the left pars interarticularis was approximately two times larger than the right in the skeletal specimens. Absolute differences were calculated between the side with the greater length and height and the side with the lesser length and height irrespective of their left-right orientations. For CT measurements, most differences in length and height between the greater pars interarticularis and lesser pars interarticularis occurred between 0 and 1 mm with each successive disparity interval yielding lower numbers. Skeletal measurements revealed a similar length disparity distribution to the CT measurements. However, height measurements in the skeletal specimens varied widely. Eight pars interarticularis specimens demonstrated a height difference between 0 and 1 mm. No dry bone pars interarticularis specimens demonstrated a height difference between 1 and 2 mm. The pars interarticularis of nine specimens demonstrated a height difference between 2 and 3 mm. Two demonstrated a height difference between 3 and 4 mm. Four demonstrated a height difference between 4 and 5 mm and two demonstrated a height difference greater than 5 mm. The greater pars interarticularis lengths and heights were combined and compared to their lesser counterparts on CT and skeletal measurements. In all measurements of this type, significant differences were found in the pars interarticularis length and height, whether measured through CT or via digital calipers. Conclusion Asymmetry between the left and right C2 pars interarticularis as shown in the present study can alter surgical planning. Therefore, knowledge of this anatomical finding might be useful to spine surgeons.

Publication date

  • 2022

Published in

International Standard Serial Number (ISSN)

  • 0930-1038

Number of pages

  • 7

Start page

  • 423

End page

  • 429

Volume

  • 44

Issue

  • 3